System Requirements:

486 dx 33
8 mb RAM 
Sound Blaster or compatibles
VGA Graphics support (1 meg video ram)
No mouse is required

Installation instructions:

1. From the MS-DOS prompt, insert the Hyper 3-D Pinball CD-ROM 
   into your CD drive and then enter the letter of that drive.  
   For example D: <enter>.
2. Type INSTALL <enter>
3. Follow the on-screen instructions.
4. To run the game, type CD\3DPINBAL <enter> and type 3DPINBAL <enter>.

Common problems and solutions:

Problem:  Game aborts after the introduction or when starting 
	  Hyper 3-D Pinball.

Solution: Try typing UVCONFIG -D7 or -D27 at the 3DPINBAL prompt or
	  you can download the Hyper 3-D Pinball Video Patch from the
	  Hyper 3-D Pinball web page. 

Problem:  Game aborts/crashes after typing 3DPINBAL.

Solution: Create a boot disk to clear out any unnecessary TSR programs.

Problem:  Not getting any sound in Hyper 3-D Pinball.

Solution: Check cable connections. 
	* Under Win3.x: Make sure you're not running Hyper 3-D Pinball 
	  from WIndows.  Try exiting Windows and running from DOS. If 
	  your system starts up in Windows, try "REM"ming out WIN in 
	  the AUTOEXEC.BAT file, powering down your computer, turning it 
	  back on, and trying Hyper 3-D Pinball again.  Make sure the 
	  drivers for your sound card and cd rom drive have been correctly
	  installed/configured. 

	* Under Win95: Check cable connections.  If you're running from 
	  Windows, re-start in MS-DOS mode.  Make sure the DOS 
	  compatible drivers for your sound card and CD-ROM drive have 
	  been correctly installed/configured. 

Problem:  How do I view the high scores?

Solution: As per the readme file (and it actually works, too):  When at
	  the main menu, press H.  The high scores for whatever table is 
	  currently selected will be shown.

Problem:  Hyper 3-D Pinball plays too fast on your computer.

Solution: There is no solution at this time.  Run in Safe Mode (selected
	  from the Main Menu), or from Windows to slow the game down.  
	  You may also try disabling Turbo.

Problem:  Hyper 3-D Pinball gives the error "Could not install UNIVBE."

Solution: Try typing UVCONFIG -D7 or -D27 at the 3DPINBAL prompt or
	  you can download the Hyper 3-D Pinball Video Patch from the
	  Hyper 3-D Pinball web page. 


Problem:  You receive a blank screen after typing 3DPINBAL.

Solution: Run SETSOUND from the 3DPINBAL directory. Make sure the sound
	  settings are correct for your system.  If you're running from 
	  Windows 95, try running from MS-DOS Mode.  Also try typing 
	  UVCONFIG -D7 or -D27 at the 3DPINBAL prompt or you can download 
	  the Hyper 3-D Pinball Video Patch from the Hyper 3-D Pinball web
	  page. 

